Compare the work your pool needs, from a seal repair to a new finish. Home and shared-property scopes are described separately below.
A leaking pump does not always need to be replaced. A worn lid gasket, shaft seal or plumbing fitting may be the only part that needs attention. A targeted repair can avoid the much larger cost of replacing otherwise sound equipment. A cracked pressure-filter tank is different: the damaged component needs replacement rather than a patch.
If an older pump keeps failing, a full replacement may be the better use of your money. We compare the condition of the motor, housing and controls before discussing a variable-speed model. The new pump needs to suit your plumbing, filter, heater and swimming routine. In Orlando heat, clear airflow and protection from direct sun help reduce equipment stress.
Rough, worn plaster can make a home pool uncomfortable and harder to keep looking clean. We assess the existing finish and discuss preparation, standard plaster and any repairs needed underneath. Draining needs planning around Florida rain and groundwater conditions. Once the pool is refilled, brushing and water-balance checks help protect the fresh finish during its startup period.
A heater that stops warming your pool may have a flow, sensor or ignition problem. We look at the fault before comparing a repair with replacement. Electric heat pumps use warmth from Orlando air, while gas heaters generally heat the water faster. Your swimming schedule, fuel supply and existing equipment help determine the practical choice.
Refilling your pool every few days is a reason to investigate water loss. We compare evaporation with possible leaks and inspect valves, seals, skimmers and return fittings. Dye testing, plumbing pressure tests or electronic listening may help locate the problem. Detection identifies where the water is going so a repair can be scoped separately.
Cloudy water or rising filter pressure can point to a dirty cartridge, a worn seal or a filtration problem. We check the filter and its connections before suggesting parts or replacement. A leaking O-ring may be a small repair, while a cracked pressure tank needs the damaged component replaced. The aim is to restore filtration without replacing equipment that still works.
A hotel or community pool pump needs to maintain the flow its filtration and treatment system requires. Commercial equipment ranges from smaller pumps to models such as Pentair’s 3–15 HP EQ series. We check leaking shaft seals, worn bearings, blocked impellers and motor or drive faults. Repair planning includes the equipment model, operating flow and the property’s pool operator.
A commercial replacement is sized around the pool’s approved design rather than a home-pool rule of thumb. We review circulation needs, the filter, pipework and connected chemical-feed equipment. A variable-speed setting must still meet the system’s operating requirements. Equipment changes are coordinated with the operator and the appropriate authority where review is required.
A shared pool needs a clear closure, resurfacing and startup plan. We help property managers review the finish, steps, depth markings, ladders and fittings alongside surface preparation. Florida public-pool work can involve more than applying fresh plaster. The schedule allows for scope-specific reviews, filling and the selected finish’s water-care instructions.
A hotel or community pool heater needs to suit the property’s heating demand and swimming schedule. We assess water flow, controls and damaged parts before recommending a major repair or replacement. Water chemistry, airflow and heat-exchanger condition all affect that decision. Replacement capacity and installation details need coordination with the existing plant and site requirements.
Automatic top-ups can hide a leak in a hotel or community pool. We review water-loss records and inspect the equipment before testing pool fittings or plumbing. Dye, pressure tests and electronic listening may help narrow the source before opening a deck. The findings give the property manager a clearer repair scope and a basis for planning downtime.
A commercial pool filter needs to handle the system’s approved flow and regular operating load. We assess pressure changes, leaking seals and damaged housings alongside the circulation equipment. Repair or replacement is planned around filter capacity, chemical-feed operation and the property’s maintenance schedule. Scope-specific review and operator coordination help keep the work aligned with the pool’s requirements.
Tell us what changed, what equipment you have and whether the pool serves a home or shared property.
Get a Quote